Isdera Commendatore 112i: Which Version Should You Buy?
Choosing an Isdera Commendatore 112i is straightforward on specification alone: the catalogue contains one generation and one version, the 6.0 MT. Produced in 1993 as a Coupe, it combines a 5,987 cm³ Gasoline engine with 408 hp, 580 Nm, a 6-speed Manual gearbox, and RWD. There is therefore no alternative engine, transmission, body, or generation to compare.
Choosing an Isdera Commendatore 112i is straightforward on specification alone: the catalogue contains one generation and one version, the 6.0 MT. Produced in 1993 as a Coupe, it combines a 5,987 cm³ Gasoline engine with 408 hp, 580 Nm, a 6-speed Manual gearbox, and RWD. There is therefore no alternative engine, transmission, body, or generation to compare. The buying decision is instead about whether this single specification suits your priorities—and whether an individual car can be assessed without catalogue figures for weight, fuel consumption, or tank capacity.
Generations: which Commendatore 112i changed what?
The Isdera Commendatore 112i has one generation in the supplied data. It ran from 1993 to 1993, used a Coupe body, and offered one version: 6.0 MT. With no second generation or additional version listed, there are no catalogue-based changes in engine output, performance, body style, transmission, or drive system to compare.
This also means there is no higher-powered derivative to seek out and no lower-powered entry model to avoid. Every comparison leads back to the same 6.0 MT specification. Claims about restylings, later generations, or other factory versions cannot be supported by the supplied data.
Isdera Commendatore 112i specs and engine
| Version | Power | Torque | Displacement | Fuel | Cylinders | Layout | Boost | Gearbox | Drive |
|---|---|---|---|---|---|---|---|---|---|
| 6.0 MT | 408 hp at 5200 rpm | 580 Nm at 3800 rpm | 5,987 cm³ | Gasoline, 95 | 12 | V-shaped | No | 6-speed Manual | RWD |
The 6.0 MT uses a centrally located 5,987 cm³ Gasoline engine with 12 cylinders in a V-shaped layout. It has 4 valves per cylinder, a compression ratio of 10, and an 89 × 80.2 bore-and-stroke specification. Its fuel system is Distributed injection (multi-point), while boost is listed as No.
Calculated from the catalogue figures, the engine produces approximately 68.1 hp per litre and 96.9 Nm per litre. Those figures do not establish whether the engine is better than another Commendatore 112i unit because no alternative unit is listed, but they describe what the single available 6.0 MT delivers from its displacement.
For a buyer, the important mechanical combination is fixed: 408 hp, 580 Nm, a 6-speed Manual gearbox, and RWD. There is no Automatic, AWD, boosted engine, or different cylinder configuration in the supplied range.
Performance, top speed, and mpg
The 6.0 MT accelerates from 0 to 100 km/h in 4.7 seconds and has a listed top speed of 330 km/h. Because it is the only version, these numbers represent the complete performance range rather than the upper end of a multi-version lineup.
Fuel consumption in the city is not measured. Fuel consumption on the highway is not measured, and combined fuel consumption is also not measured. Consequently, a catalogue-based mpg figure cannot be calculated or used to compare potential purchases. CO₂ output is not measured, and the eco class is not measured.
The available figures support a performance-led choice, but they do not quantify operating economy. Anyone comparing individual cars should keep those two evidence levels separate: 4.7 seconds to 100 km/h and 330 km/h are listed, while consumption and emissions figures are unavailable.
Dimensions, weight, ground clearance, and wheels
Kerb weight for the 6.0 MT is not measured, and gross weight is not measured. A weight-per-horsepower figure is therefore not measured and cannot be calculated responsibly from the supplied information. This is especially important when searching for Isdera Commendatore 112i weight data: the catalogue does not provide a number that could support a power-to-weight comparison.
Ground clearance is 140 mm. The listed wheel sizes are 225/35 R18 and 295/35 R18. Fuel-tank capacity is not measured.
Both the front and rear suspension are Independent, spring. The front brakes are Ventilated disc, while the rear brakes are Disc. These specifications are common to the only listed version, so they do not create a trim-level choice.
Which Isdera Commendatore 112i version should you buy?
On the supplied catalogue evidence, choose the 6.0 MT if you want the Commendatore 112i at all. It is not merely the recommended version among several choices; it is the sole version listed for the sole generation. It gives you the model’s only documented package: 408 hp, 580 Nm, 5,987 cm³, a 6-speed Manual gearbox, RWD, 4.7-second acceleration to 100 km/h, and a 330 km/h top speed.
There is no numerical case for paying extra for another version because no other version and no price data are supplied. Likewise, there is no evidence here for choosing an earlier or later generation: the catalogue records only the 1993 generation. Questions about Isdera Commendatore 112i price, cars for sale, or how many were made cannot be answered from these data.
The main limitation is missing ownership-related information. Kerb weight, gross weight, city consumption, highway consumption, combined consumption, tank capacity, CO₂ output, and eco class are all not measured. Those gaps do not create an alternative recommendation; they define what must be verified separately when assessing a particular car.
The resulting verdict is unambiguous: the 6.0 MT is the version to buy if its fixed specification matches your needs. There is no catalogue-supported upgrade, economy alternative, different gearbox, or newer generation to choose instead.